UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions.

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1   Report Post  
Frank
 
Posts: n/a
Default Supplying Power to a Garden Garage

Hi, I'm looking to find out how to install electricity in a garden
garage. I plan to have a washing machine and a socket or 2 for Power
Tools. I also want to power some low voltage garden lights and power
a water feature.

I need to know what type of cable I should get to carry the
appropriate power. I assume I should put a consumer unit in the
garage but need to know what I'm looking for.

Also running the cable under ground may not be possible as I would
have to dig up an area of patio and concrete.

Any help is much appreciated.
  #2   Report Post  
Dave Plowman
 
Posts: n/a
Default Supplying Power to a Garden Garage

In article ,
Frank wrote:
I need to know what type of cable I should get to carry the
appropriate power.


SWG cable commonly called armoured. Have a look at TLC for an idea of the
ratings available. They sell it cut to length - some suppliers will only
sell a drum.

www.tlc-direct.co.uk

--
*Happiness is seeing your mother-in-law on a milk carton

Dave Plowman London SW 12
RIP Acorn
  #3   Report Post  
Christian McArdle
 
Posts: n/a
Default Supplying Power to a Garden Garage

Hi, I'm looking to find out how to install electricity in a garden
garage.


Normally, you would run SWA armoured cable. Thickness required depends on
length and load. I'd install a B32A MCB in the house and run the cable from
there. It only has to switch to armoured cable as it leaves the house.
Inside you can use normal PVC T&E.

In the garage, install an insulated consumer unit and an earth block fed
from an earth rod driven into the ground. Isolate the cable earth and do not
connect it to anything. Connect up any required main equipotential bonding
to the earth block. This is required for structural metalwork or metal
services, such as water pipes.

Depending on budget and likely use, the consumer unit should consist of
either an RCD only system with a 30mA RCD and MCBs, or (better) a Type S
100mA RCD and a mixture of MCBs and RCBOs as appropriate (socket circuits
then must be off an RCBO).

If the garage is close to or attached to the house, you can skip the earth
rod and use the SWA armour. This may only be practical if there is no main
equipotential bonding to hook up, as this would then need to be wired back
to the house earth block.

Christian.


Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
power flushing Andy Hall UK diy 4 September 9th 03 11:59 PM
Power to Garage and Shed/workshop Eric the Red UK diy 3 August 29th 03 06:22 PM
Installing power sockets and light into an adjacent garage Andy Hide UK diy 0 July 21st 03 10:00 AM
Building a garage above public sewer (UK) Capitol UK diy 3 July 15th 03 11:43 PM


All times are GMT +1. The time now is 08:54 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 DIYbanter.
The comments are property of their posters.
 

About Us

"It's about DIY & home improvement"