On 4/7/2011 4:36 PM, Han wrote:

If you can get away with it, consider putting the rabbet in the end
panel (as below) ... you'll have a stronger joint and won't need to edge
band the bottom, except on the front edge that shows.

Here is what I was working on the afternoon that I mentioned in the wRec
just a few minutes ago.

All the front edges on this light-box shelf are edge banded with iron on
maple banding.

--
www.e-woodshop.net
Last update: 4/15/2010
KarlC@ (the obvious)

Swingman wrote in
:

On 4/7/2011 4:36 PM, Han wrote:

If you can get away with it, consider putting the rabbet in the end
panel (as below) ... you'll have a stronger joint and won't need to edge
band the bottom, except on the front edge that shows.

Here is what I was working on the afternoon that I mentioned in the wRec
just a few minutes ago.

All the front edges on this light-box shelf are edge banded with iron on
maple banding.

Of course, that is how I should do it.

I've done a fair amount of iron-on (oak) veneering of edges. I want to do
something else. At least try it. If I can't get it nice enough I can
still go the ironing route.

--
Best regards
Han
email address is invalid