Home |
Search |
Today's Posts |
![]() |
|
About this forum Any questions or feedback on what this forum is or how this forum operates. |
Reply |
|
LinkBack | Thread Tools | Display Modes |
#1
![]() |
|||
|
|||
![]()
I have a furnance that runs. But after the burners flame goes out the blower runs constantly and will not shut off. Does anyone have the solution to this problem. Thanks Rusty.
|
#2
![]() |
|||
|
|||
![]()
No, nut a long time ago I had the same problem with a furnace. Never did figure it out. I'd like to hear an explanation.
|
#3
![]() |
|||
|
|||
![]()
Rusty if it is an older furnace it has a heat chamber control that tells the blower to start it also tells it to stop if it is adjusted to low of a temp it keep blowing or it is stuck and won't turn the blower off
|
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
SONY 35" Dual PIP -Video Blackout Problem | Electronics Repair | |||
Furnance in Woodshop - House Air Quality | Woodworking | |||
Paslode IM250A Cordless Finish Nailer, Stripped Treads Problem | Woodworking | |||
Widespread problem with HP Omnibook XE3-GFs? | Electronics Repair | |||
Problem with retrace lines on EIZO F55S... | Electronics Repair |