WD wrote:
On Sat, 05 Feb 2005 13:05:29 -0800, mac davis

wrote:

Yea, Larry send him your prototype, but you send me the 1.5hp motor.
You should
be able buy another motor for even less than what you pay for it
earlier. :-)

While planning to make a thickness sander, I have found various sites
you might
be interested. You might wanna add a DC geared feed conveyer in the
near future,
here are some website's for Thickness sanders parts:

thanks.

I'm not sure how I would attach the conveyor. The bottom of the table
is blocked off where it attaches to the base via the piano hinge. I
think any commercial sander would be support by its corners, and the
bottom would be open.

I would also have to check out how the board would stay on the conveyor
without being flung across the room!