"Kalico" wrote in message
...
"Andrew Mawson" wrote in message
...

"Kalico" wrote in message
...
"Andrew Mawson" wrote in message
Bosch angle grinder in toool box for last 7 years - no idea of price
Threading of hex bar simple job on lathe - took 10 minutes as I have
the
appropriate tooling
Speed controller - haven't a clue as I didn't use one.

Andrew Mawson

So when can you start mass producing these and selling them to use for
a
reasonable cost? Sure there must be a market for a gadget like that.

Rob




I'm prepared to make a few adaptors if you have the angle grinder with a
14mm stud and the appropriate 3/8" UNF male chuck. What are people
prepared
to pay ?

Andrew Mawson

You suggest something - how long would they take to make?



Well it's the usual story - it's not the actual job that takes the times
it's the setting up and clearing up afterwards. Actually doing the job -
probably 4 per hour - say £7.50 plus postage if enough people respond. Note
this is ONLY to make the adaptor - 14mm female to 3/8" UNF female - you need
your own chuck with a 3/8" unf male stud, and an angle grinder with a 14mm
stud (they mostly are) and the use you put it to is ENTIRELY at your own
risk.

If 10 people want them I'll make em

Andrew Mawson