"PoP" wrote in message
...
On Tue, 17 Feb 2004 18:34:14 -0000, "stuart noble"
wrote:

Yeah, only ever used to drill square through joists. No market at all
really, apart from plumbing and electrics. :-)

I sent an email earlier today to NuTool, putting forward a suggestion
that they might like to think about bringing out an angle drill, and
also a laminate trimmer. I enclosed links to the tools I was
suggesting to ensure they fully understood what I was referring to. No
response as yet and perhaps there never will be.

However both of these devices are well within NuTool capabilities to
mass produce, and they could mop up if they brought out tools at a
sensible price.

If enough people put forward the same suggestions I'm sure the
relevant notice might be taken.

NuTool do not make them. Jinding make them and put NuTools name on them.
The tools are from a standard catalogue. If Jinding make an angle drill
then Ferm or NuTool, etc could have one. Jinding made 14 million power
tools in 2003. Their catalogue is downloadable from the web site. You may
recognise some of the tool types which may be called NuTool, Challenge, etc.

http://www.jinding.com/