In article ,
Richard Cline wrote:
In article , "hdjoe"
wrote:
...
There are many options available to you. When you purchase your lumber
yoou can usually get the yard to make one cut with their panel saw.
This will get you to approximately the dimension you want. An output
roller stand makes an enormous difference in feeding long pieces through
your table saw. It need not be attached to the saw. ...

That's why the Lee Valley roller stand
http://www.leevalley.com/wood/page.a...=1,24 0,41060
is on my wish list. One nice thing is that it will take up very little
storage space.

I hadn't thought of it before, but it also could be used for an infeed
table when needed - probably I should put several of them on my wish
list!
--
--henry schaffer
hes _AT_ ncsu _DOT_ edu