"ClemsonDave" wrote in message
...


Ok, how about an easy way to make a 90 degree miter sled? Any tricks?
dave


After I finish 'dorking with an Outfeed table on that damned Jet Supersaw,
that's next on the Jig List. My attempt will entail cutting a right-angle
triangle off a piece of 3/4" MDF. Figure the factory corner should be 90
degrees.

Like Barry said - as long as you cut your miters using both sides, and the
net/net is 90 degrees, they should fit. Even if one is 46 degrees (relative
to the blade) the other side should be 44.

Ultimate router table, hell.
Real dorkers spend time building uber-sleds...