seems to me that you would be wasting a lot of phenolic as compared to a
table saw cutting it into strips.

--

http://users.adelphia.net/~kyhighland


"cornytheclown" wrote in message
om...
Is it possible to use a router table with the fence set back several
inches from the bit and using the bit, a 3/16 straight cutter to rip
down some phenolic sheet into strips ???

I am going to fabricate a metal table top and mount the router in the
center and just use a piece of heavy sheet metal angle as a fence. I
will mount the fence with bolts as this is a one time use....

I once had a router table years and years ago and didnt use it much
but for playing around. And I dont remember having the fence away from
the bit several inches as I need to have it now.

Anyhow, what I am planning is to mount the router in the center and
will bolt the fence down to the rear of the router and feed in from
the right to left. I hate to ask such a stupid question but the
phenolic I have is limited and I dont want to have to waste any more
than neccesary getting familiar with my setup.

any replies or suggestions would be greatly appreciated.