On 12/15/2009 11:23 AM, Mike and Lora wrote:
"Lee Michaels" wrote in message
...

Lots of mortices there.

Did you rout them out and square them up with a chisel?

I deviated from the plans I had which called for using a jig and router
and creating dados in each inner face. I used the radial arm saw to cut the
dados. I then cut each of the railings slightly oversized and used the
jointer to creep up on each of the mortises. Some (most) of the mortises
required a little bit of paring with chisel to make it a tight fit. Time
consuming to say the least, but it seemed to work out quite well. Thanks
for the feedback!


Were those the plans from Woodsmith? I made a bed that looks almost
exactly the same using Woodsmith plans a few years ago...

--
Kevin Miller - http://www.alaska.net/~atftb
Juneau, Alaska
In a recent survey, 7 out of 10 hard drives preferred Linux
Registered Linux User No: 307357, http://counter.li.org