Mike and Lora wrote:
"Lee Michaels" wrote in message
...

Lots of mortices there.

Did you rout them out and square them up with a chisel?

I deviated from the plans I had which called for using a jig and router
and creating dados in each inner face. I used the radial arm saw to cut the
dados. I then cut each of the railings slightly oversized and used the
jointer to creep up on each of the mortises. Some (most) of the mortises
required a little bit of paring with chisel to make it a tight fit. Time
consuming to say the least, but it seemed to work out quite well. Thanks
for the feedback!

Did you *glue* all those verticals into the mortises? If so, it looks like a
potential glue-up nightmare to me! You'd definitely want to use a glue with a
long open time...

--
See Nad. See Nad go. Go Nad!
To reply, eat the taco.
http://www.flickr.com/photos/bbqboyee/