"Roger Mills" wrote in message
...
In an earlier contribution to this discussion,
Vass wrote:

following my turntable creation, the spindle on the motor is slipping
pressed against the timber
what couldI wrap/stick on the spindle to create better adhesion that
will not wear off?

some form of rubber I thought?
TIA

What diameter is it? Would one of those rubber caps intended for the end
of walking sticks fit?


its approx 12mm diameter with a key slot in it.
I'm running agains the shaft approx 30mm from the end to ensure it does'nt
run off.
--
Vass