Thread: Carver TX-2
View Single Post
  #6   Report Post  
Posted to sci.electronics.repair
[email protected] joemanenti@yahoo.com is offline
external usenet poster
 
Posts: 7
Default Carver TX-2

On Jan 26, 2:30*pm, "DaveM" wrote:
wrote in message

...
On Jan 26, 6:00 am, "Mark D. Zacharias"
wrote:





wrote in message


...


I just got a Carver TX-2. It works great but when I use the auto-tune
it will only lock onto an even number freq. I think its set to the the
european freq standard. Does anyone know if it can be changed? I
thought there might be just a switch but I cant locate it. Thanks, Joe


If the unit is equipped with an AM section, see if it tunes in 9kHz
increments. If so this would confirm your theory about the Euro frequencies.


I'm not so sure this is your problem, however. The few Euro units I've seen
mostly tune in 50mHz steps on FM, unlike 100 mHz US models, but you could
still tune in a US station using such a tuner. Your tuner may have some
other issue - the discriminator out of adjustment, for example. This could
make it lock off to one side of station center frequency. Can you set the
tuning mode to "manual" (as opposed to "Auto") and get the correct frequency
to display?


If it is the Euro frequency issue, you can try pressing and holding a
certain button or say two buttons at once while plugging it in, or turning
on the power switch if it's a "hard" on-off type.
Sometimes the FM button or freq UP button while plugging in, for example..


You might get lucky.


Mark Z.
The auto-tune works correctly on AM. On FM if the freq is 91.9 it will
lock on 92.0 but if I switch to manual I can put it on the correct
freq. Is the discriminator something I could adjust myself (I'm not a
tech)? Thanks for your help, Joe


That's the typical symptom of the set being set for European FM standards. *Look
on the rear of the chassis for a switch *that is labeled something like Chan
Spacing, (Eur)opean/US, or something similar. *The switch might even be inside
the unit, so the cover might have to be removed to find it. *Make sure it's on
the US or 200KHz channel spacing position. * Your receiver should work properly
(unless it's malfunctioning).

--
Dave M
MasonDG44 at comcast dot net *(Just substitute the appropriate characters in the
address)

"In theory, there isn't any difference between theory and practice. *In
practice, there is." *- Yogi Berra- Hide quoted text -

- Show quoted text -


There's no switch on the back and I removed the cover but I could find
a switch. I'll take another look. Thanks