Gerald Ross wrote:
I have made a round bottom bowl which sits in a stand resembling an
inverted bowl with the bottom cut out.

When sitting on it's stand it wants to move around too easily. Need
suggestions for what to use in the interface to minimize this. Felt?

ISTR that 3M makes a two-sided clear adhesive tape. A couple small spots
of that ought to do the trick. Especially if the small spots are
opposite each on the on the bowl & base.

Bill

--
I am disillusioned enough to know that no man's opinion on any subject
is worth a **** unless backed up with enough genuine information to make
him really know what he's talking about.

H. P. Lovecraft


---
avast! Antivirus: Outbound message clean.
Virus Database (VPS): 000716-3, 02/23/2007
Tested on: 2/23/2007 10:54:42 PM
avast! - copyright (c) 1988-2007 ALWIL Software.
http://www.avast.com