TonyM wrote:
I see. What about texturing or carving the one surface to increase the
coefficient of friction.
Tony Manella
ndd1"at"prolog.net (remove "at")
http://home.ptd.net/~ndd1/
Lehigh Valley Woodturners



"Gerald Ross" wrote in message
...
I have made a round bottom bowl which sits in a stand resembling an
inverted bowl with the bottom cut out.

When sitting on it's stand it wants to move around too easily. Need
suggestions for what to use in the interface to minimize this. Felt?
--
Gerald Ross

I'm going to try the little plastic bumps first, but will
keep that in mind. I have already textured the bowl at the
bottom but can't do it where it meets the base. Thanks.

--
Gerald Ross
Cochran, GA

Sex is like a bridge game: If you
don't have a good partner, you'd
better have a good hand.