"MinnJim" wrote in message
ups.com...
Hi,
Somewhere in this group I remember seeing a bit on holding the "lip"
of a bowl to finish turning the tenon etc. of the base. I"m using a
Talon 4 jaw chuck on a base tenon, but hate cutting/sanding off the
tenon after I've completed the inside/outside part of the bowl. If I
remember correctly it was a wooden addition/jaws set up to be used
with the 4 jaw chuck. It may have been a face plate/wood jaw device
also? I've tried searching this group but can"t find it. Any help
would be appreciated.
MinnJim

Imagine you're looking for the Longworth Chuck.

Fred's reprint from Woodturning is a good place to start.
http://www.fholder.com/Woodturning/chuck.htm