Thread: Clamping Cauls
View Single Post
  #12   Report Post  
Posted to rec.woodworking
Larry Blanchard Larry Blanchard is offline
external usenet poster
 
Posts: 2,532
Default Clamping Cauls

Jay Pique wrote:

You can cut them much faster on a table saw. Put one board on top of
another, screw through one end into the board below. Now, etiher by
hand or using C clamps or whatever, bow the top board so it's
now-bowed edge extends over the lower board. While it's stressed like
this, screw down the other end to the lower board. Then cut on
tablesaw, & voila, one curved board. (Not sure, credit to FWW I think)


Maybe someone with a CNC router could start selling templates.**Until
then, I think this is the way to go.


I think you're all getting carried away. I just took a hand plane and cut what
seemed to be adequate. Been using them for years. Don't overcomplicate
things.

--
It's turtles, all the way down