|
Posted to rec.crafts.woodturning
|
|
|
Help with Nova DVR:"FAULT RP state error 0".
" wrote:
Hi Irwin
I was going to put a smartass answer in here like buy a Oneway lathe,
but that would not be much help for you right now, however there's a
group (Nova) site, for trying to help with all those problems that the
nova lathes seem to have, and sorry no I don't have the address. so
this is still not much better, but all I have.
Have fun and take care
Leo Van Der Loo
ias wrote:
Nova DVR users ... please help!
I am getting the following error message on my Nova DVR: "FAULT RP
state error 0". I downloaded a FAQ page from the Nova (Teknatool) web
site and followed the instructions to the letter ... However, the
problem persists.
There is never a good time for technical difficulties, but
unfortunately timing couldn't be worse. I am right in the middle of
finishing a few piece which are scheduled to go on gallery display in
two weeks and so I am feeling pretty desperate for an urgent fix.
Please reply as soon as possible. Thanks in advance.
Best regards,
irwin
Some ware in my favourites:
http://groups.msn.com/NovaOwners/messages.msnw
--
Gerard
|