I was hoping someone could point us to a site that would show pictures of
all the various profiles, eg the 'Irish', the 'fingernail' the 'roughing',
the 'this' and the 'that' and what have you, complete with suggested bevel
grind angles and techniques to get there. This information is probably
available for the various grinds/profiles but, I think, all on different
sites. Such info would probably save a lot of steel by narrowing the
expirementation window. Sounds like a project.

Tom

"George H Hughes" wrote in message
news:9eWDf.8$8D6.7@dukeread11...
Can someone tell me where I might find a chart showing the typical bevel
that turning tools are ground to the first time. Some of my tools have
gotten out of whack I am sure and I want to get them back to the typical
where and can then start to find the bevel that works for me.
I have never found this information listed all in one place before.
I know everyone will find the bevel that works for them but I need to get
back to that point and get a start on find my sweet bevel.
Thanks to everyone....
George Hughes
Warner Robins, GA